Extron Electronics VN-Matrix 200 Series - Manual (Page 20)

Network Communications Setup
To establish a serial communication link…
1. Using a null modem serial cable, connect the serial port of a PC or laptop to the
Remote serial port on the VNC 200 to be configured.
12V DC
5A MAX
POWER
1 — LAN — 2
IN
OUT/
LOOP
AUDIO
SPDIF
REMOTE TO PC IN
IN DVI-I OUT/LOOP
RS-232
OVER LAN
VNC 200
Power
Source
PSU
Figure 10. Establishing a Serial Communication Link
2. On the PC or laptop, run a terminal emulation program such as HyperTerminal with
the following comm settings:
Baud rate:
115200
Data bits: 8
Parity: None
Stop bits:
1
Flow control: None
NOTE: HyperTerminal is supplied with most Windows ® operating systems.
VN-Matrix 200 Series • Installation 15