Extron Electronics VN-Matrix 200 Series - Manual (Page 41)

g
If the source type is RGsB (sync on green), ensure that SoG is checked as shown below.
Otherwise, it should be left unchecked as shown in the previous diagram. This forces
the output format to be the same as the chosen source.
Figure 30. Selecting a Source Stream
h
Select one of the available source streams as shown above.
Each source is listed by the device name, videoPort name, and suffixed by the
connection type.
• _rtp is an RTP Unicast connection
• _rtp(m) is an RTP Multicast connection
• _tcp is a TCP Unicast connection
i
If the chosen source has an audio channel, check the audio enable checkbox.
Otherwise, leave the box unchecked as shown in the previous diagram.
j
Click the Update button and the Save All tab as shown above. The chosen source
should now appear on the output display. If it does not, see “ Display Checkup .”
Additional Information for Decoder Setup
Identify mode
As an aid to setting-up a VNC 200 decoder in a large or complex system, use the
Identify function to display the device name on the display output.
NOTE: Source Identify displays the name of the source stream that is being
decoded. The text appears to the right of the Identify text.
VN-Matrix 200 Series • System Configuration 36