Extron Electronics VN-Matrix 200 Series - Manual (Page 25)

Hubs are not suitable for use with the VNC 200 as they restrict bandwidth.
NOTE: For normal VNC 200 operation, use Network Port 1 only.
TIP: With the VNC 200 powered and connected to a network, the Network
Status Indicator (next to the network connector) should be lit, as follows:
Connecting a digital source
12V DC
5A MAX
POWER
1 — LAN — 2
IN
OUT/
LOOP
AUDIO
SPDIF
REMOTE TO PC IN
IN DVI-I OUT/LOOP
RS-232
OVER LAN
SOURCE COMPUTER
DVI monitor out keyboard mouse SPDIF audio out
NETWORK
DVI
MONITOR
Power
Source
DVI-D
to
DVI-D
PS/2
to
PS/2
VNC 200
(Encoder)
IMPORTANT!
Fit clip-on ferrite
to this end of cable
PSU
Phono
to
Phono
Figure 11. Connecting a Digital Source
VN-Matrix 200 Series • Installation 20