Extron Electronics VN-Matrix 200 Series - Manual (Page 29)

System
Configuration
This section describes the following:
• VNC 200 Web Interface
• Configuring a VNC 200 as an Encoder (Source)
• Configuring a VNC 200 as a Decoder (Display)
• Troubleshooting
VNC 200 Web Interface
Once all VNC 200 devices have been correctly set up for (and connected to) a network,
any further system configuration is achieved via the VNC 200 web interface. This contains
a number of pages which provide access to various system parameters.
TIP: This section provides step-by-step instructions for using the web interface and
is aimed at new users of the VNC 200 system. Advanced users may wish to
see
Technical Data .
The web interface is “served up” by the VNC 200 device that was designated as
the controller during the network setup procedure (see “
Setup and Connection
Procedure ”). It can be viewed by any up-to-date web browser, running on a PC or a
laptop that is connected to the same network as the VNC 200 devices.
Suitable browsers include, but are not limited to:
• Microsoft ® Internet Explorer (v6 and above)
• Firefox ® , Mozilla ® (v1.3 and above)
NOTE: Whatever browser is used, it must be configured to accept cookies and
be JavaScript-enabled. For further help on configuring your browser, see
“
Browser Configuration ”.
Accessing the web interface
1. Enter the IP address of the controller device into the address bar of the web browser,
for example,
http://192.168.0.18 . The following web page illustration appears in
the web browser.
VN-Matrix 200 Series • System Configuration 24