Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 103)

Visit the Alpha website at www.alpha.ca for the latest manual and product downloads
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 101 of 122
9.3.2 Computer Setup
1. In Windows® 2000, select START menu, SETTINGS, and then select NETWORK
AND DIAL-UP CONNECTIONS.
2. Double-click the MAKE NEW CONNECTION icon to start the Network Connection
Wizard.
3. Select DIAL-UP TO PRIVATE NETWORK. Note: Some systems may come up with
another pop-up selection for modem or infrared port. Modem should be selected.
4. Enter the phone number for the Cordex (this field can be blank and the phone
number may be entered in the pop-up connection window, see note below).
5. Select FOR ALL USERS or ONLY FOR MYSELF as required. Then select NEXT to
continue.
6. Select a Unique name for the Cordex connection; for example, “SiteName
CXC.modem.” Then select FINISH to continue. Note: A dialup connection interface
may appear. (If not, enter the phone number as in step 4. If in Step 5, FOR ALL
USERS was selected, then there is no need to enter user name and password.
Leave these two fields blank.)
7. Select PROPERTIES. Ensure the correct modem appears under “CONNECT
USING.” Then select CONFIGURE to continue.
8. Change MODEM SPEED (BPS) to 57600. Deselect all HARDWARE FEATURES and
select OK to continue.
9. Select the NETWORKING tab (Dial-up Connection Properies window).
10. Select Internet Protocol (TCP/IP). Then select PROPERTIES to continue.
11. Select OBTAIN IP ADDRESS AUTOMATICALLY and select OK to continue.
Launch Internet Explorer® version 6.0 or greater to access the Cordex web interface. Type the address
http://10.10.10.203 into the URL section.
9.3.3 CXC Modem Test Feature (via Web interface only)
This feature is a modem dial out test and can only be done using the web interface with Ethernet (Local or
Remote) connection. Refer to controller setup and computer setup above.
1. Connect the computer modem to a phone jack.
2. Establish connection between controller and computer and launch CXC user web
interface.
3. Once the connection is established, navigate to HARDWARE and then TEST
MODEM (Figure 113).
4. Enter the TELEPHONE NUMBER.
5. Click on TEST MODEM to initiate test.
Figure 113–Test Modem web interface window