Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 43)

Visit the Alpha website at www.alpha.ca for the latest manual and product downloads
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 41 of 122
6.4.3 Charge Current Control (CCC)
6.4.3.1 Enable
This menu item enables the Supervisor to control the CXC’s Charge Current Control feature.
Battery Properties section must be completed to enable this feature.
6.4.3.2 Charge Rate Limit
This menu item enables the Supervisor to program the amount of current that goes into the
battery and is dependent upon the Supervisor-entered parameter Capacity Rating (C), see
6.4.8.1. The Charge Rate amount is represented in amps (X) or as a C/X value (Capacity
Rating/Charge Rate Amps).
The Charge Rate Amps is recalculated if the Charge Rate C/X value or the Capacity Rating is
modified.
Figure 34–Charge Current Control web interface window
6.4.3.3 Enable Dynamic CCC
This menu item enables the Supervisor to control the CXC’s Dynamic Charge Current Control
feature. Battery Properties section must be completed to enable this feature.
NOTE: There is a separate set of Charge Rate Limit values that can be input for the
Dynamic CCC feature.
6.4.3.4 Battery Properties (See 6.4.8)
The “Battery Properties” button at the bottom of the Charge Current Control window is a link to
the Battery Properties window.
The return path (the menu structure) will remain intact; i.e., the user will return through the
window where the Battery Properties button was tapped.
Dynamic CCC Trigger
This pull-down menu enables the Supervisor to
select the event that triggers the Dynamic CCC
feature (if enabled).