Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 60)

Refer to the back of this manual for Factory Service and Technical Support contact information
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 58 of 122
6.5.7 Configure ALCO
This feature is found under the Global Alarm Configuration menu (submenu of Alarms), see Figure below:
Figure 45–Configure ALCO window
6.5.7.1 ALCO Duration
This menu item enables the user to program the duration in minutes; that all ALCO enabled
alarms will be affected by the parameters set by this feature. Tap on the number to edit via a
virtual numeric keypad.
6.5.7.2 Enable ALCO Duration
This menu item enables the user to control the ALCO Duration feature.
6.5.7.3 Silence Buzzer
This menu item enables the user to control the audible alerts for ALCO enabled alarms.
6.5.7.4 Revert Relays
This menu item enables the user to control the state of ALCO enabled relays.
6.5.7.5 Stop Sending Email
This menu item enables the user to control the transmission of Email communications.
6.5.7.6 Stop Sending SNMP Traps
This menu item enables the user to control the transmission of SNMP communications.
6.6 Signals
This menu category consists of system identifiers and calibration controls. Parameters can be set/accessed such
as controller signals, rectifier signals, analog and digital inputs. With the web interface, data logging may be
performed.
Toggle the check box to select
Accept changes and
return to previous screen
Sliders and scroll bars
are used for navigation
Select menu item to configure
Discard changes and
return to previous screen