Alpha Technologies Cordex Controller Ver.2.0 - Manual (Page 85)

Visit the Alpha website at www.alpha.ca for the latest manual and product downloads
Alpha Technologies Ltd. 034-136-C0 Rev B WC
Printed in Canada. © 2010 Alpha Technologies Ltd. ALPHA and CORDEX are trademarks of Alpha Technologies Ltd. All Rights Reserved. Page 83 of 122
6.9 Hardware
This menu category consists of output relay configuration and testing. See also 6.5.3.1 for Overview.
6.9.1 Configure Relays
This menu item will display a list of the normal state of all the existing output relays. A relay must be selected in
order to configure the settings. See Figure 86 below.
From the pop-up menu, the Supervisor can configure the relay for email notification and/or SNMP dial out trap
notification. The Supervisor can also toggle polarity; that is, specify if the relay is normally energized or normally
de-energized.
Figure 86–Configure Relays window
6.9.2 Test Relays
This menu item will display a list of the present state of all existing output relays. See Figure 87 below.
From this menu the Supervisor can toggle the state; that is, specify if the relay is presently energized or de-
energized to verify its condition. Change of state will be temporary as all relays return to their default states after
leaving this menu.
Figure 87–Test Relays window
6.9.3 Test Modem (Web Interface only)
See 9.3.3.
Tap Toggle State to test selected item
A message of warning will be displayed
before allowing the toggling of an LVD relay
to enable the user to cancel the operation.
Select menu item to test
Discard changes and
return to previous screen
Sliders and scroll bars
are used for navigation
Select from the
pop-up menu
Select relay then tap
Configure Settings