Antex Electronics StudioCard AV Pro, StudioCard 2000, & SC-22 - Manual (Page 20)

C h a p t e r 1 I n s t a l l i n g Y o u r S t u d i o C a r d
1-14 Antex StudioCard Copyright © 1997
Step 13 Locate an available 25-pin D connector punch-out on the back
panel of the computer and remove the punch-out. (The cable
bracket has been designed not to require a typical computer
bracket which would waste a card slot. It fits in a 25 pin D
connector punch out available near the power supply of most
computer cases.)
If there is no 25 pin punch-out available, you must procure a
bracket with a hole for a 25 pin D connector. The bracket
requires the same size cutout as a parallel port connector and
is available at most computer stores.
Step 14 From the inside of the computer, insert the Video Cable
Assembly mounting plate into the punch-out, then secure it in
place with the two screws provided. Label which BNC you
have connected to Video In and Video Out on the card.
A properly
installed Video
Cable Assembly
should look
like that
shown at
right.
Step 15 Replace the cover on your computer and secure it in place with
the screws you removed earlier.
The next step in the StudioCard installation process is to
connect your external A/V equipment to the StudioCard. Refer
to the instructions beginning on page 15.