Antex Electronics StudioCard AV Pro, StudioCard 2000, & SC-22 - Manual (Page 30)

C h a p t e r 1 I n s t a l l i n g W i n d o w s 9 5 / 9 8 D r i v e r s
1-24 Antex StudioCard Copyright © 1997
Note
Installing
Windows
95/98 Drivers
To install the Windows 95/98 drivers, simply follow the step-
by-step instructions below.
Please note that the Antex Demo and Antex Mixer are
installed separately from the drivers in Windows 95/98.
Installation instructions for these programs follow this section.
Be sure to check Antex’ web site periodically for the latest
StudioCard drivers. Our web address is www.antex.com.
It is recommended the files are unzipped, copied to a
floppy, and installed from the floppy disk.
Step 1 After installing the StudioCard, power on the computer.
Windows 95/98 Plug and Play will recognize the new hardware
and ask you to install drivers for it.
Insert the Windows 95/98 Driver and Software diskette into the
floppy drive, PN 9000-2390-7002.
Step 2 The following dialog
box will appear.
Verify “Driver from
disk provided from
hardware
manufacturer” is
checked, and click
OK.