Antex Electronics StudioCard AV Pro, StudioCard 2000, & SC-22 - Manual (Page 55)

C h a p t e r 3 Mi x e r C o n t r o l s a n d I n d i c a t o r s
3-6 Antex StudioCard Copyright © 1997
Main Screen
Control Description
1 Line In Trim Trim slider control used to adjust the clipping level of the analog input signal to either
+12 dBu or +24 dBu. Output trim is moved in unison. See Chapter 4 for more
information regarding levels.
2 Rec 1 level
controls
Level controls used to adjust the volume of the left and right stereo signal at the Rec
1 channel. If Rec 1 is defined by the application software to be mono rather than
stereo, only the left slider and 1-4 buttons (Item 3) are valid. The relative signal level
is indicated by the level indicators (item 11).
3 Rec 1
1, 2, 3, 4
1, 2, 3 & 4 selector buttons, highlighted when selected. These buttons represent the
physical inputs 1-4 as marked on the analog I/O cable. Only one can be selected at a
time. Used to select which of the four analog signal inputs (1 - 4) will correspond to the
left and right inputs to this device (only left column is valid for a mono device).
4 Line In
On/Off
On/Off selector button, highlighted and reads On when selected, Off when
deselected. Mutually exclusive with Digital In selector button. When selected, the
input signal to the Mixer is an analog signal supplied via the DB25 analog
input/output connector on the back of the StudioCard.
5 Digital In
On/Off
On/Off selector button, highlighted and reads On when selected, Off when
deselected. Mutually exclusive with “Line In” selector button. When selected, the
StudioCard is set for digital input and expects digital data via the digital I/O cable.
When digital in is enabled, it replaces analog inputs 1 and 2. Application software
recording from device 1 with digital in enabled expects data input digitally.
6 Play 1 AVol Avol (Automatic Volume adjustment) selector button, highlighted in green when
selected. Used only during playback of Mono files. When selected, the StudioCard
duplicates data and volume settings of the left half of the playback device to a
second physical output. Output 1 is copied to Output 2, Output 3 is copied to Output
4 in the default configuration. Stereo files are played back normally.
7 Play 1
1, 2, 3, 4
1, 2, 3 & 4 selector buttons, highlighted when selected. These buttons represent the
physical outputs 1-4 as marked on the analog I/O cable. Multiple buttons may be
selected, routing a file from disk to multiple physical outputs.
8 Play Output
Level Control
Stereo pairs of level controls for the four analog output channels. When a file is
mono, only the left slider is valid.
9 Line Out
Trim
Trim slider control used to adjust the clipping level of the analog output signal to
either +12 dBu or + 24 dBu. Input trim setting is moved in unison. See Chapter 4 for
more information regarding levels.
10 Line Out
Output Level
Indicators
Indicators, one for each of the four analog signal outputs. Indicate the relative signal
level at each output, leftmost meter is output one, rightmost output four.
11 Rec 1 Level
Indicators
Level indicators that indicate the relative level of the left and right stereo signal at the
Rec 1 channel. The signal level is affected by the setting of level controls (item 2).