eLine Technology EYS-VMS eyStream User Manual Part1 - Manual (Page 24)

24
Based on the video signal coming in from the IP device, an assessment is made of the guarded
location and the system responds to events registered for that location. The content and quality of
the obtained video information depends on how the IP device is installed and configured. There
are a number of rules that must be followed to obtain a high-quality video signal. In particular,
high-quality peripheral equipment (switch/router) must be used; Home/Office devices, which are
not intended for use in these kinds of security systems, are unacceptable.
Note
IP devices connected to such equipment will transmit a video stream with an
unacceptably long delay (from 1.5 to 3 seconds per frame)
Detailed information about creating a local network and connecting IP equipment to it is presented
in the corresponding reference documents.
Configuring IP Devices in Windows
IP devices can be configured in Windows by using the following software:
1. Software included with the IP device This software is used to accomplish the following tasks:
a. Searching for network devices connected to the local network
b. Preliminary IP address assignment (without account of routing)
Attention!
Without assigning preliminary IP addresses to the devices, it is not
possible to access their Web interface
2. Web interface of the IP device. This interface is used to accomplish the following tasks:
a. Configuring the IP devices with consideration for routing
b. Configuring modes for the IP devices to work with video and audio signals
c. Viewing video images coming in from IP devices in standard Web browser mode
Configuration of IP devices in Windows is described in detail in the official reference
documentation for the respective devices.
Particulars of Configuration of Devices
eLineTechnology.com 303.938.8062