eLine Technology EYS-VMS eyStream User Manual Part1 - Manual (Page 76)

76
Note
Patrolling is enabled through the Patrolling button in the PTZ camera
control panel (see the section titled
Patrolling ).
5. Set the interval of time (in seconds) at which the PTZ device will switch between presets
while in Patrol mode.
6. Click the Apply button.
The PTZ device will then be switched to its assigned work mode.
To check the functioning of the PTZ device, click the Test button. If the PTZ device is configured
correctly, it will turn one step and return to its original position.
The Sensor Object
If a sensor is physically connected to the system independently of a video camera, then you must
specify the video camera to which it will be linked in the settings of the given sensor. When you
do this, the Sensor object will appear under the specified Camera object in the object tree.
Note
This setting is used to link alarms initiated by the triggering of a sensor to a
video camera
eLineTechnology.com 303.938.8062