eLine Technology EYS-VMS eyStream User Manual Part1 - Manual (Page 77)

77
Note
This setting is relevant only for sensors connected to IP servers. The sensor and
the video camera to which it is to be linked must be connected to the same IP
server
If the sensor is embedded in a video camera or physically connected to it, then its corresponding
object will be automatically displayed in the objects tree as a child of that particular video camera.
To configure a Sensor object, perform the following:
1. Select the Sensor object in the objects tree (1).
2. Enable the device (2).
3. Enter the name of the sensor (3).
4. Set the status to which the sensor will be set when no alarm is present.
5. Click the Apply button.
The sensor will then be switched to its assigned work mode.
The current status of the sensor is displayed in the Sensor information group.
The Relay Object
If a relay is physically connected to the system independently of a video camera, then you must
specify the video camera to which it will be linked in the settings of the given relay. When you do
this, the Relay object will appear under the specified Camera object in the object tree.
eLineTechnology.com 303.938.8062