Burkert Type 1062 - Manual (Page 14)

14
Technicaldata
Type 1062
Version with double
inductive switch (4-wire)
• statuses detected
• valve open or closed
indication mode
• colour of the lights
depending on the
status detected
• power up light
• valve open and valve closed
• using lights and electrical signal via
terminal block
• an orange light comes on when the
valve opens and a red light comes on
when the valve closes
• green
Version with double
inductive 2-wire NAMUR
switch
• statuses detected
• valve open or closed
indication mode
• colour of the lights
depending on the
status detected
• valve open and valve closed
• using lights and electrical signal via
terminal block
• an orange light goes off when the
valve opens and a red light goes off
when the valve closes
6.4.3 General data specific to the devices
approved by csA
Degree of pollution Degree 2, acc. to EN 61010-1
Installation category Category I, acc. to EN 61010-1
Height above sea level max. 2000 m
Electric power supplied by an SELV (Safety Extra Low
Voltage) source
6.4.4 electrical data
Connection cable standard, diameter between 5 and
7 mm, max cross-section of the strand
1 mm
2
Mechanical contact
version (per contact)
• Power supply of
devices approved by
CSA and CE
• Power supply
of devices only
approved by CE
• Power consumption
• Allowable load
• Type of output
• 12-30 V AC or
12-48 V DC
• 12-30 V DC or
12-48 V DC/V AC or
48/110 V DC/V AC or
110/250 V DC/V AC
• < 35 mA (48 V DC)
< 8 mA (220 V AC)
• depending on the power supply
voltage and the type of load, inductive
or resistive: see „Table 1“ next page
• contact normally open or normally
closed
english