Basic safety information, 3basic safety information – Burkert Type 1062 User Manual

Page 7

Advertising
background image

7

Basicsafetyinformation

Type 1062

3

bAsic sAfeTy
infoRmATion

This safety information does not take into account:
• any contingencies or occurences that may arise during assembly,

use and maintenance of the devices.

• the local safety regulations that the operator must ensure the staff

in charge of assembly and/or maintenance observe.

Risk of explosion.
When the 1062 is used in an ATEX 21 or 22 zone, make sure:
• That the cover of the electrical position feedback is always

screwed shut before operating the valve.

• That you check that the device is not subject to a flow of air and

dust that may result in an accumulation of electrostatic charges.
Otherwise, intall the device in a conductive cover.

• "The NAMUR switches on the 1062 must be powered by a voltage

source of a type certified for use in explosive atmospheres in
groups IIB/IIC and their combination must be compatible from the
instrinsic safety point of view."

Danger due to high pressure in the installation.

▶ Shut down the pneumatic power source and depressurise the

pipes before carrying out work on the device.

Risk of injury due to electrical discharge.

▶ Shut down the electrical power source of all the conductors and

isolate it before carrying out work on the system.

▶ Observe all applicable accident protection and safety regula-

tions for electrical equipment.

Various dangerous situations
To avoid injury take care:

▶ to prevent any power supply switch-on.

▶ to ensure that installation and maintenance work are carried out

by qualified and skilled staff with the appropriate tools.

▶ to guarantee a set and controlled restarting of the process, after

an electrical and/or pneumatic power supply interruption.

▶ to use the device only if in perfect working order and in compli-

ance with the instructions provided in the user manual.

▶ to observe the general technical rules when locating and using

the device.

• not to use non-Ex certified versions of the 1062 electrical position

feedback in a potentially explosive atmosphere.

english

Advertising
This manual is related to the following products: