Burkert Type 1062 - Manual (Page 3)

3

1. About this mAnuAl ................................................................................ 5
1.1. symbols used ...................................................................................... 5
1.2. Definition of the word "device" ................................................... 5
2. intenDeD use ............................................................................................... 6
2.1. Restraints ............................................................................................... 6
2.2. ex certification ..................................................................................... 6
3. bAsic sAfety infoRmAtion .............................................................. 7
4. GeneRAl infoRmAtion .......................................................................... 8
4.1. manufacturer's address and international contacts ........ 8
4.2. Warranty conditions .......................................................................... 8
4.3. information on the internet ........................................................... 8
5. DescRiption .................................................................................................. 9
5.1. Area of application ............................................................................ 9
5.2. General description .......................................................................... 9
5.2.1. Construction ...........................................................................9
5.2.2. Principle of operation ...........................................................9
5.3. Description of the name plate on the standard 1062 .... 9
5.4. Description of the name plates on the 1062 AteX ...... 10
5.5. Versions available ........................................................................... 11
6. technicAl DAtA ....................................................................................... 11
6.1. conditions of use ............................................................................ 11
6.2. conformity of the 1062 AteX to standards
and directives .................................................................................... 11
6.3. conformity of the 1062 approved by csA ......................... 12
6.4. General technical data ................................................................. 12
6.4.1. Mechanical data .................................................................12
6.4.2. General data ........................................................................13
6.4.3. General data specific to the devices approved by
CSA .......................................................................................14
6.4.4. Electrical data......................................................................14
7. Assembly ...................................................................................................... 16
7.1. safety instructions.......................................................................... 16
7.2. Replacing the top part of an actuator size 40mm ......... 17
7.3. fitting the position feedback to a pneumatic actuator 17
7.4. fitting the position feedback with stroke
limiter to a pneumatic actuator size 50 to 80mm ......... 19
7.5. fitting the position feedback with stroke
limiter to a pneumatic actuator size 100 or 125mm .... 23
Type 1062
TableofContents
english