Fluid Components International Quality Assurance Manual - Manual (Page 45)

DOCUMENT NUMBER
07QA070003
SUBJECT
Quality Manual
CAGE CODE
64818
RELEASE DATE
10-8-2012
SECTION
2
PAGE
4
CURRENT
REVISION
L
1.0 SCOPE
The requirements described in this section, Section Two, of the Quality Manual
provide an overview of FCI‟s quality system as it relates to all projects identified
as “Controlled for Aerospace”.
In accordance with the provisions of 14 CFR, Part 21, the Federal Aviation
Administration has found that the design data submitted by FCI meets the
airworthiness requirements of the Federal Aviation Administration applicable to
the product on which the parts are to be installed. Additionally, it has been
determined that FCI has established the quality system required by 14CFR Part
21.137 (a) – (n) and is granted Parts Manufacturing Approval for production of
the replacement parts or modification parts, as applicable, listed in the
Supplements to the Parts Manufacturer Approval Letters in conformity with the
Federal Aviation Administration-approved data. The terms and conditions
applicable to this approval are documented in the Federal Aviation Administration
– Parts Manufacturer Approval Letter.
If the physical location of FCI changes, or if additional locations of FCI are
included under this program, the Federal Aviation Administration (FAA) shall be
notified immediately in writing of the relocation of any manufacturing facilities or
addition in accordance with terms 2 and 7 of the Parts Manufacturing Approval
(PMA) Letter.
This Manual, in its entirety, unless identified otherwise, shall be issued as a
controlled document to FCI‟s customers having contractual obligations to this
section of the manual.
2.0 REFERENCED DOCUMENTS
This manual is supplemented by numerous procedures as identified in Appendix
“B” and referenced throughout this manual. Procedures other than those
referenced may also be used to implement the quality management system.
3.0 REFERENCES
AS9100 (current revision) Quality Systems – Aerospace- Model for Quality
Assurance in Design, Development, Production, Installation, and Servicing
Note: All references to AS9100 in either FCI procedures or this QAM shall be
deemed to refer to the latest revision of the standard regardless of the revision
stated at the time of conception.
Mil-I-45208A – Military Specification, Inspection System Requirements
14CFR21.137 - Aeronautics and Space, Code of Federal Regulations, Approval of
Materials, Parts, Processes, and Appliance - Replacement and Modification Parts