Fluid Components International Quality Assurance Manual - Manual (Page 65)

DOCUMENT NUMBER
07QA070003
SUBJECT
Quality Manual
CAGE CODE
64818
RELEASE DATE
10-8-2012
SECTION
2
PAGE
24
CURRENT
REVISION
L
a) Identification throughout the product life;
b) The ability to trace all products manufactured from the same batch of raw
material, or from the same manufacturing batch, to the destination (e.g.,
delivery, scrap),
c) For an assembly, the ability to trace its components to the assembly and then
to the next higher assembly, and
d) For a product, a sequential record of its production (manufacture, assembly,
inspection/verification) to be retrievable.
FAA-PMA IDENTIFICATION
When the Federal Aviation Administration (FAA) has granted Parts
Manufacturing Approval (PMA) for production of modification or replacement
parts, the parts shall be marked in accordance with 14CFR45.15 with the
following:
a)
“FAA-PMA”
b) The name, trademark, or symbol of PMA holder
c) The part number
Note: If the item is too small to record all of the above information, and approval
is obtained from the FAA, the information may be placed on a tag attached to the
item or attached to the individual container for the item.
7.5.4 CUSTOMER PROPERTY
FCI exercises care with customer property (including intellectual property and
personal data while it is under the organization‟s control or being used by the
organization. FCI identifies, verifies, protects, and safeguards customer property
provided for use or incorporation into the product. Occurrence of any customer
property that is lost, damaged, or otherwise found to be unsuitable for use is
recorded and reported to the customer and records maintained.
7.5.5 PRESERVATION OF PRODUCT
FCI preserves the product during internal processing and delivery to the intended
destination in order to maintain conformity to requirements. As applicable, this
preservation includes identification, handling, packaging, storage, and protection.
Preservation also applies to constituent parts of a product.
Preservation of product also includes, where applicable in accordance with
product specifications and/or applicable regulations, provisions for: