Impulse 463N - Manual (Page 59)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 59
Start the Ethernet Config utility (Start  All Programs  Sealevel SeaMAX  Ethernet Config)
installed with SeaMAX. In the „Available SeaI/O Devices‟ pane, you should see a “SeaIO Wireless”
module listed under Model, as shown below.
If the module doesn‟t show up, click the “Search for SeaI/O Devices” button. The „Available
SeaI/O Devices‟ pane should refresh with any Ethernet or Wireless SeaI/O modules that are
found on the network.
At this point, since no DHCP server is available, the wireless SeaI/O module will default to a
random IP address in the range 192.168.0.x.
Notice that the „Name‟ is not displayed due to the wireless SeaI/O module residing on a
different subnet than your wireless adapter. Ethernet Config will mask the „Name‟ of SeaI/O
modules operating on a different subnet than the subnet you are currently using.
Take note of the IP Address of the wireless SeaI/O module listed in the „Available SeaI/O
Devices‟ pane. You will need this number in order to continue.
Also, make sure that the MAC Address shown matches the MAC Address on the label on the
bottom of the wireless SeaI/O module. If the MAC address doesn‟t match, contact technical
support for further assistance.
Close Ethernet Config before continuing.