Impulse 463N - Manual (Page 82)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 82
Replace the metal strain relief. Start both screws
and tighten only until snug. Do not over-tighten.
Replace the top half by starting it on the left side
over the connectors and then snapping the right
side down into place. Be careful not to pinch
fingers. Replace both screws on each side and
then replace the terminal block on the left side.
Continue with the installation of the SeaI/O-463
module. The SeaI/O Hardware Description section
of this manual contains information on TTL
applications and optional accessories. The SeaMAX
Application Suite section walks you through setting
up the hardware address (Slave ID) and software
installation.