Impulse 463N - Manual (Page 98)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 98
SeaI/O Mounting Kit (Part# KT122)
Expanding your I/O count is as simple as adding N-
Series expansion units to the Base SeaI/O module
(or other N-series modules). Each N-Series module
includes an expansion and strap kit (Part# KT122),
which includes a 5” CAT5 interconnect cable, four
metal straps, and four #4-40 metal screws. The
image shows a SeaI/O stack configuration using
the expansion kit.
DIN Rail Mounting (Part# DR104)
All SeaI/O modules are available with a factory-
installed DIN-rail mounting clip. Alternatively DIN-
rail mounting clips can be ordered as a field
upgrade kit (Part# DR104). The bracket with clip is
easily attached using two included #4-40 Phillips
head machine screws.
Table/Wall Mounting (Part# KT123)
The flush mount bracket kit (Part# KT123) is
extremely versatile and can be used to mount
SeaI/O modules from the top, bottom, or back
edge. Individual modules or a stack of SeaI/O
modules can be mounted flat to a tabletop,
underneath a counter, or inside an enclosure. The
kit can be used to mount SeaI/O modules flat to a
wall, or along the back edge, similar to DIN-rail
mounting options.
Universal Mounting Bracket (Part# KT125)
The universal mounting bracket (Part# KT125) can
be used as a “backpack” to mount power supplies
and other devices to SeaI/O modules. The bracket
has holes for both 75mm and 100mm VESA
mounting options. The universal arrangement of
slots and holes accept bolt sizes to M4 and can be
used for virtually any mounting configuration.