Impulse 463N User Manual
Page 70
©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual
70
Set the slave ID of the “base” wireless SeaI/O module using the rotary switch or software
selection method discussed in the Setting Device Address section (MaxSSD chapter) of this
manual. This guarantees that any expansion modules connected next will not conflict with the
“base” module. Perform another Get operation to verify that you can communicate with the
“base” wireless SeaI/O module at the new slave ID.
Configure the SeaI/O modules one at a time. Set the address to a hardware slave ID other
than “0” or a software slave ID other than 247, to avoid device conflicts during setup.
After the “base” wireless SeaI/O module is successfully communicating via MaxSSD, you can
proceed with adding SeaI/O expansion modules (N-series). Refer to the Configuring Expansion
Modules section of this manual.