Impulse 463N - Manual (Page 75)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 75
Before recovery begins, make certain that the PC and Ethernet SeaI/O module are on the same
network segment – they should be connected with an Ethernet crossover cable, through a hub,
or through a non-routing switch. Ethernet SeaI/O modules are shipped with both an Ethernet
patch cable (blue) and an Ethernet crossover cable (yellow).
Enter the MAC address found on the label on the bottom of the SeaI/O enclosure. A MAC
address is made up of six pairs of hex digits separated by dashes (i.e., xx-xx-xx-xx-xx-xx).
While entering the MAC address, the indicator to the right of the field will turn red if the MAC
address entered is invalid. Once a MAC address is successfully entered, the indicator light will
turn green and the “Network Settings” options will be enabled.
Contact your network administrator if you are unsure of the proper network settings to choose.
If a DHCP server is available, select the “Enable DHCP Configuration” checkbox. Otherwise,
complete the network settings and click the “Recover Module” button to complete the
configuration changes.
Proceed with configuring expansion modules, explained in the previous section.