Impulse 463N - Manual (Page 68)

©Sealevel Systems, Inc.
SL9049 - 11/2010
SeaI/O Manual 68
To complete the configuration, you need to change the IP Address of your wireless adapter back
to its original settings. Open the Network Connections utility (Start  Settings  Network
Connections). Right-click on your network adapter and select Properties.
On the General tab, select „Internet Protocol (TCP/IP)‟, leave the box checked, and then click the
Properties button.
In the Internet Protocol (TCP/IP) Properties window, change the settings for your wireless
adapter back to the original settings you noted at the beginning on this section. Click the OK
button in this window. Click the OK button on the Wireless Network Connection Properties
window.
Your wireless adapter should now be configured for your wireless network and the wireless
SeaI/O module should now be properly configured to work with your wireless network. You can
open Ethernet Config to verify. If you have any problems, please contact Sealevel technical
support at
[email protected] .