Max Machinery 121 INDICATOR - Manual (Page 37)

121-000-350 © 2001 Max Machinery, Inc. Pg 37
STOP
START
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
ENTER
6.4.22
SETUP
DATALOG/PRINT
(Select_list)
List Items:
Total
Rate
Pre1
temp
grand
pre2
dens
time
6.4.23
ADMINISTRATIVE
SETUP
SET DATALOG/PRINT
SET DATALOG/PRINT
Config Select_list
PRINT LIST ITEMS
TOTAL
YES
PRINT LIST ITEMS
RATE YES
PRINT LIST ITEMS
PRE 1 YES
PRINT LIST ITEMS
DataLog size =001489
Advance To
ADMINISTRATIVE SETUP
ADMINISTRATIVE SETUP
OPERATOR PASSWORD
*****
S U P E RVISOR PA S S W O R D
*****
SOFTWARE VERSION
vxx.xx
PRODUCT ORDER CODE
121 SERIESxxxxxxx
UNIT SERIAL NUMBER
00000
SENSOR SERIAL N U M B E R
00000
Advance To
SETUP NETWORK CARD
Press enter to begin Setup Datalog/Print routine.
Press enter when Select_list is selected to setup print list.
Use Up and Down arrow keys to view list status.
Press the Corresponding function key to the items that
you wish to add or remove from the list.
Items marked with Yes will be added to the list,
items marked with No will be removed from the list.
The Select Print List Information display shows the cur-
rent possible Datalog size.
Press Enter to begin Administrative Setup.
Enter Operator Password. (Factory Set to 0)
Enter Supervisor Password.
(Factory Set to 2000)
This display is used to show the software version of the
installed software.
This display is used to show the product order code
(model number).
This display is used to show the unit's serial number.
This display is used to show the sensor's serial number.