MaxPower Corp Gamatronic Power+ SA - Manual (Page 91)

Gamatronic Electronic Industries Ltd.
POWER+ SA User Guide (UL), Release 1.0 85
20.1.1 Installing the P OWER + SA for 2-phase usage
Follow the following steps to Install the UPS and prepare it for initial
start-up:
To install the UPS and prepare it for initial start-up:
1. Verify that the external circuit breakers in the mains electrical cabinet for UPS
input, UPS output, and bypass are OFF. No voltage should be present in the
cables.
2. Verify that the battery cabinet circuit breaker is OFF.
3. Remove the protective cover from the UPS rear panel.
4. Connect the UPS wiring according to the labeling on the unit, shown in Figure
20-4 on page 86.
Figure 20-3: UPS rear panel with protective cover