Power off the switch – Alcatel-Lucent Omni 6600 User Manual
Page 117
Managing OmniSwitch 6600 Family Stacks
Setting Up a Stacked Configuration
OmniSwitch 6600 Family Hardware Users Guide
September 2006
page 4-9
2
Change the slot number by gently pressing the pointed item into the SEL hole again. Each time the
SEL button is pressed, the LED display increases or decreases in increments of one.
SEL Button Location
3
Continue pressing the SEL button until you reach the number that is one increment higher that the
desired slot number, then hold in the SEL button until the LED decreases one increment (to your desired
number) and stops flashing.
4
Power off the switch.
5
Continue steps 1 through 4 for any additional switches that are being assigned new slot numbers.
6
Continue to
“Connecting Cables to Stacking Ports” on page 4-11
Note. Refer to the illustration on
for one of many valid slot numbering possibilities.
3
4
5
6
7
8
9
10
12
14
16
1
2
TM
OmniSwitch 66
24
OK1
OK2
PS1
PS2
PRI
SEC
TEMP
FAN
28
30
32
34
25
26
CO
NSO
LE
SEL
OK1
OK2
PS1
PS2
PRI
SEC
TEM
FAN
SE
L