Alcatel-Lucent Omni 6600 - Manual (Page 70)

OmniSwitch 6600 Family Chassis and Hardware Components Installing MiniGBICs
OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-46
Installing MiniGBICs
Each OS6600-GNI-U2 uplink module supports up to two MiniGBICs on OmniSwitch 6624, 6600-U24,
6600-P24, and 6648 switches. On OmniSwitch 6602-24 and 6602-48 there are two built-in MiniGBIC
ports for MiniGBICs. These MiniGBICs are packaged separately and therefore are not factory-installed.
You can install the MiniGBIC(s) by following the steps below:
Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the MiniGBIC, as well as the switch
and uplink module.
1 Holding the MiniGBIC by its sides, carefully slide it into the desired MiniGBIC slot in the OS6600-
GNI-U2 module on OmniSwitch 6624, 6600-U24, 6600-P24, and 6648 switches or the built-in MiniG-
BIC ports on OmniSwitch 6602-24 and 6602-48 switches, as shown.
Inserting the MiniGBIC (OS6648 Shown)
Note. The MiniGBIC should slide in easily. Do not force the MiniGBIC into the slot. Otherwise you can
damage the connectors. If any resistance is encountered, ensure the MiniGBIC is aligned and oriented
properly, as shown in the diagram above.
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
1
2
EX PAN SIO N/S TA CKIN G
EXP ANSIO N 49
50
51
52
TM OmniSwitch
6624
OK 1 OK 2 PS1 PS2
PR I SEC
TEM P FAN
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
25
26
CO NSO LE
SEL
EXP
ANSION/S
TA CKING
51
52