Alcatel-Lucent Omni 6600 - Manual (Page 66)

OmniSwitch 6600 Family Chassis and Hardware Components Removing Uplink and Stacking Modules
OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-42
Removing Uplink and Stacking Modules
To remove an uplink or stacking module from the chassis, follow the steps below:
Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the switch and the uplink or stack-
ing module.
1 Loosen the two captive screws, located at the left and right sides of the module’s front panel. If neces-
sary, use a Phillips screwdriver to loosen the screws.
Note. Be sure that both captive screws are completely disengaged from the threaded holes in the chassis
before continuing.
Loosening the Captive Screws
EXP
ANSION/ST
ACKING
51
52
LIN
K/A
CT
LINK
/AC
T