Alcatel-Lucent Omni 6600 - Manual (Page 55)

OmniSwitch 6600 Family Chassis and Hardware Components Backup Power Supply
OmniSwitch 6600 Family Hardware Users Guide September 2006 page 2-31
Installing a Backup Power Supply
You can add a backup power supply to the chassis at any time without disturbing the switch’s network
functions. You are not required to power down the switch.
Note. This section only applies to OmniSwitch 6624, 6648, and 6600-U24 switches.
Hot Swapping
Hot swapping a backup power supply refers to the action of replacing the unit while the switch is operat-
ing. Again, because it is a backup (i.e., redundant component), you are not required to power off the
switch’s primary power source.
To add the optional backup power supply to the chassis, follow the steps below:
Anti-Static Warning. Before handling any component, free yourself of static by wearing a grounding
strap, or by grounding yourself properly. Static discharge can damage the switch and the backup power
supply.
1 Locate the backup power supply bay. The backup power supply bay is located at the switch’s rear
panel. Refer to page 2-20 for a view of the chassis rear panel.
2 If there is a blank cover panel installed at the backup power supply bay, uninstall it by removing the
two Phillips attachment screws. After the attachment screws have been removed, carefully pry the blank
cover panel out and away from the chassis. Set the cover panel and attachment screws aside.
3 To avoid attempting to install the backup power supply upside down, orient the unit as shown in the
diagram below.
Orienting the Backup Power Supply
!
CA UT ION
: THIS UNIT
MA Y BE EQUIPP
ED
WITH TWO
POW ER CONNEC
TIONS. T
O REDUCE
THE RISK OF E
LECTRICAL
SHOCK, DISC
ONNECT
BOTH PO
WER C
ONNEC
TIONS BEFORE
SER VICING UNIT
.
ATT
EN TIO
N: CET APP AREIL
COMPOR
TE
PLUS D'UN COR
DON D'ALIMEN
TAT ION . A FIN DE
PREVENIR LES
CHOCS
ELECTRIQUES
, DEBRANCHE
LES DEUX COR
DONS D'ALIME
NT AT ION A
VA NTE DE
FA IRE LA
REP ARA TION.
50 /60 H
z, 2/2/1 A 100 /115/230 V
Orient the backup power
supply with the vent side
up, as shown.
Top