Electro Cam 5000 Series - Manual (Page 22)

3-10 Wiring
Introduction
The PS-5X34 system is available with either 32 or 64 low
current transistor outputs. These systems are intended to
be interfaced directly to PLCs or other control devices with
low level DC inputs.
The 32 transistor output rack(s) used with PS-5X34 controls
can be DIN rail mounted (-D) or foot mounted (-F) and are
available with Sinking or Sourcing outputs.
Systems that require 32 or fewer outputs will only need one
of the transistor output racks. Systems requiring more than
32 outputs need two transistor output racks daisy chained
together (see rack configuration section below).
The PS-5X34 controller incorporates the same keyboard
and features that other PS-5000 controls use. Because of
the large number of outputs being controlled, the number of
programs stored in a 32 output controller is 32, and the
number of programs in a 64 output controller is 16.
This control has PS-5XX4 capabilities (output grouping and
modes) and includes an RS-232/485 communications port.
Outputs can be subdivided into as many as 8 groups, and
the position of each of these groups can be offset individually.
Because the rack transistor outputs cannot be configured
as inputs, the only enable input available is the "Output
Group Enable 1" input located on the logic strip. Output
Group 1 can operate in any output mode, all other groups
must operate in Mode 0 only.
To PS-5X34 Control Control systems requiring 32 or fewer outputs will need only
1 PS-4100-12-X32 transistor output rack. The "Rack
Address Jumper" must be plugged into position 1. This will
configure the outputs to be channels 1-32. 1 rack cable (Pt#
PS-4300-02-XXX) will be needed to connect the rack to the
controller.
Control systems requiring more than 32 outputs will need 2
PS-4100-12-X32 transistor output racks. The "Rack Address
Jumpers" must be plugged into position 1 on one of the
racks, and position 2 on the other. Output channel numbers
will be assigned as shown in the illustration to the right. 2
rack cables (Pt# PS-4300-02-XXX) will be needed: one to
connect the controller to the first rack and the other to
connect the two racks.
Output Rack Configuration
*DIN Rails must be ordered separately
3"
(76mm)
DIN Rail Mount*
DIN Rail
EN 50022
DIN Rail
EN 50035
1/4" (6mm)
9"
(229mm)
PS-4100-12-X32-X Dimensioned Drawing
Foot Mount
2-1/2"
(64mm)
2-13/16"
(72mm)
3-1/8"
(79mm)
L
C
1/2" (13mm)
7/8"
(22mm)
0.168" (4.3mm)
For #8 Screw
Brackets (2) on
Foot Mount Version (-F) Only
PS-5X34 Controller & 32 DC Output Rack