ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 23)

Maintenance Tests
9650-001356-01 Rev. D ZOLL X Series Service Manual 17
5.0 Heart Rate Alarm Test
Equipment Fluke Impulse 7000DP Analyzer
Do this... Observe this... Pass/Fail
5.1 Press the Leads quick access key
( ) on the X Series unit and
select lead II.
II displays next to the Leads quick
access key. o o
5.2 On the X Series unit:
• Press the More quick
access key ( ) key to
access the second set of
quick access keys.
• Press the Alarm quick
access key ( ).
• Press the Limits softkey.
The Alarm Settings menu displays. o o
5.3 On the X Series unit, select HR/PR
Alarm in the Alarm Settings menu
and use the navigation keys to do
the following:
• Set the Upper Limit Enable
to ON.
• Set the Lower Limit
Enable to ON.
• Set the Lower limit to 35.
• Set the Upper limit to 150.
Use the navigation keys to exit the
Alarm Settings menu.
5.4 On the X Series unit, press the
Alarm Cancel quick access key
( ).
The red alarm suspension timer
displays at the top of the screen next
to the message area.
5.5 Remove a lead wire from the ECG
simulator .
T he ECG LEAD FAULT message
displays.
o o
5.6
On the X Series unit, press . The Alarm Suspend key flashes .
5.7 Reattach ECG Lead wire to ECG
simulator .
The ECG LEAD FAULT message no
longer displays. o o
5.8 Set simulator to 30 BPM or lower. Heart Rate Value is highlighted and
the alarm tone sounds. The HR/PR
LOW ALARM message displays.
5.9
On the X Series unit, press . The Alarm Suspend key flashes. The
red alarm suspension timer displays
at the top of the screen next to the
message area.
o o
5.10 Set the simulator to 120 BPM.
5.11 On the X Series unit, press
. Alarm is enabled. The alarm suspend
key flashes. The alarm suspension
timer disappears. o o
I, II,
III...