ZOLL X Series Monitor Defibrillator Rev D - Manual (Page 82)

C HAPTER 3 D ISASSEMBLY P ROCEDURES
76 9650-001356-01 Rev. D
Removing the EtCO
2
and NIBP Modules
Tool Required
• # 1 Phillips screwdriver with torque capability
• Wooden stick
• Large diagonal cutters
• Metal Pick
Setup
• This procedure should be conducted on a static mat.
• Wear a wrist strap to ground during the procedure.
• Complete these procedures in the following order before performing this procedure:
1. “Removing the Handle” on page 63
2. “Removing the Printer Module” on page 64
3. “Disassembling the Main Unit” on page 66
4. “Removing the Front Enclosure Module” on page 70
To assemble the EtCO
2
and/or NIBP modules, reverse the steps.
EtCO
2
and/or NIBP Disassembly
1 Unplug the power connector
by press on the tab and
puling straight out.