Proface PS4800 - 19 Panel PC" - Manual (Page 121)

PS-4600 Series User Manual
121
Installing Instructions
Before installing The UPS system, shut down Windows® in an orderly fashion and
remove all power from the device.
By integrating the charging circuit in the Industrial Personal Computer housing,
installation is reduced to merely attaching the connection cable to the UPS Battery
Unit mounted next to the Industrial Personal Computer.
NOTE: Due to the construction of these batteries, you can store and operate the
UPS Battery Unit in any position.
Follow the steps when installing the UPS system:
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
 Remove all power from the device before removing any covers or elements of
the system, and prior to installing or removing any accessories, hardware, or
cables.
 Unplug the power cable from both the Industrial Personal Computer and the
power supply.
 Always use a properly rated voltage sensing device to confirm power is off.
 Replace and secure all covers or elements of the system before applying power
to the unit.
 Use only the specified voltage when operating the Industrial Personal
Computer. The AC unit is designed to use 100...240 Vac input. The DC unit is
designed to use 24 Vdc. Always check whether your device is AC or DC
powered before applying power.
Failure to follow these instructions will result in death or serious injury.
Step Action
1 Disconnect the power supply to the Industrial Personal Computer.
2 Touch the housing or ground connection (not the power supply) to discharge any
electrostatic charge from your body.
3 Install the UPS Battery Unit, according to the drilling template. Ensure that the dis-
tance between the UPS Battery Unit and the Industrial Personal Computer allows
them to be connected with the UPS Connection Cable (3 m). Installation requires
4xM5 screws, 4 washers and 1 screw lock (min. torque 1.3 Nm; screw depth as
per applicable DIN regulations and specific application). These are not included in
the delivery.