Installation requirements, Warning, Caution – Proface PS4800 - 19 Panel PC" User Manual
Page 48
Dimensions/Assembly
48
Installation Requirements
Important Mounting Information
Overheating can cause incorrect software behavior, therefore:
Ensure that environmental characteristics (see page 42) are respected.
The Industrial Personal Computer is only permitted for operation in closed rooms.
The Industrial Personal Computer cannot be situated in direct sunlight.
The Industrial Personal Computer vent holes must not be covered.
When mounting the Industrial Personal Computer, adhere to the allowable
mounting angle.
WARNING
UNINTENDED EQUIPMENT OPERATION
Do not place the Industrial Personal Computer next to other devices that might
cause overheating.
Keep the Industrial Personal Computer away from arc-generating devices such
as magnetic switches and non-fused breakers.
Avoid using the Industrial Personal Computer in environments where corrosive
gases are present.
Install the Industrial Personal Computer in a location providing a minimum
clearance of 10 mm (0.39 in.) or more on the left and right sides, 50 mm
(1.96 in.) or more on the rear side, and 100 mm (3.93 in.) or more above and
below the product from all adjacent structures and equipment.
Install the Industrial Personal Computer with sufficient clearance to provide for
cable routing and cable connectors.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
CAUTION
OPERATOR INJURY
DO NOT touch the edge of mounting plate strongly.
Confirm the finger position on mounting to avoid pinching operator's finger
between the Industrial Personal Computer and mounting enclosures.
Failure to follow these instructions can result in injury.
CAUTION
UNINTENDED EQUIPMENT DAMAGES
Confirm the position of an enclosure and a touch panel and mount them carefully
not to contact with them strongly, when you mount the Industrial Personal
Computer onto enclosures.
Failure to follow these instructions can result in equipment damage.