Proface PS4800 - 19 Panel PC" User Manual
Page 136
Advertising
Hardware Modifications
136
NOTE: This procedure describes how to install a slot expansion with 1 or 2 slots.
The table below describes how to install a slot expansion:
Step
Action
1
Disconnect the power cord to the Industrial Personal Computer.
2
Touch the housing or ground connection (not the power supply) to discharge
any electrostatic charge from your body.
3
Remove the Industrial Personal Computer from the control cabinet and follow
the steps in Industrial Personal Computer Installation (see page 52) in reverse
order.
4
Place the Industrial Personal Computer on a clean and flat surface.
5
Remove the 2 marked Torx screws (T10) in the following figure and slide the
cover plate forward to remove it:
Advertising
This manual is related to the following products: