Proface APL3000B - Node Box PC - Manual (Page 29)

PL3000 Series Hardware Manual
2-2
2.1 PL-3000B Series
A: Hardware reset switch (RESET)
Restarts the PL unit during normal operation
status.
In the Soft OFF status, resets the unit to the normal
operation status.
B: DVI-I interface (DVI-I)
Interface with DVI monitor or analog RGB monitor.
DVI-I 29 pin socket type.
C: Ethernet interface (LAN1)
10BASE-T/100BASE-TX/1000BASE-T Auto
Changeover. This interface uses an RJ-45 type
modular jack connector (8 pins).
D: Ethernet interface (LAN2)
10BASE-T/100BASE-TX Auto Changeover. This
interface uses an RJ-45 type modular jack
connector (8 pins).
E: Expansion slot
For expansion board (PCI).
2 slots or 4 slots.
F: Expansion slot cover
Expansion slot cover is removed when mounting
expansion board and DIM module
G: HDD slot
For serial ATA HDD/SSD unit. HDD slot 0 and
then HDD slot 1 from the bottom
H: USB interface (USB1/2/3/4)
4 ports. USB 2.0 compatible.
Type-A connector is used.
I: Speaker output interface (SPK)
Mini pin jack connector
J: HDD status lamp
From bottom in diagram: the status lamp for HDD
slot 0 and one for HDD slot 1
LED Indicates
Green (lit)
HDD/SSD mounted
(Normal operation)
Not lit No HDD/SSD mounted
Front
(2 slot type)
Front
(4 slot type)
C
C O D
M
G
D
M
O
E
A
B
G
J K
J L
H I N Q P
J
J
L
K
I Q N P
E
B
A
H
F
F
Left side
(2 slot type)
F
Left side
(4 slot type)
F