Proface APL3000B - Node Box PC - Manual (Page 96)

Chapter 5 Installation and Wiring
5-5
5.1.2 PL-3600
∗/PL-3700∗/PL-3900T Series
This section describes the procedures and precautions for installing the PL units.
„ Check the Installation Gasket’s Seating
It is strongly recommended that you use the installation gasket, since it absorbs vibration in addition to
repelling liquids.
For the gasket installation procedure, see “6.3 Replacing the Installation Gasket (page 6-5)”.
„ Creating a Panel Cut
Create the correct sized opening required to install the PL, using the installation dimensions given.
SEE
6.3 Replacing the Installation Gasket (page 6-5)
• Before installing the PL into a cabinet or panel, check that the installation gasket
is securely attached to the unit.
• A gasket which has been used for a long period of time may have scratches or
dirt on it, and could have lost much of its dust and drip resistance. Be sure to
change the gasket periodically (or when scratches or dirt become visible).
SEE
PL-3600T Series
4.2.4 Panel Cut Dimensions (page 4-11)
PL-3600K Series
4.3.4 Panel Cut Dimensions (page 4-15)
PL-3700T Series
4.4.4 Panel Cut Dimension (page 4-20)
PL-3700K Series
4.5.4 Panel Cut Dimension (page 4-24)
PL-3900T Series
4.6.4 Panel Cut Dimensions (page 4-28)
• Check that the installation panel or cabinet’s surface is flat, in good condition and has no
jagged edges.
• Panel thickness should be from 1.6mm [0.06 in.] to 10.0mm [0.29 in.]. Even if
panel thickness is within recommend range for "Panel Cut Dimensions", the
panel could warp, depending on panel's material and installation location of PL or
other devices. To prevent panel warpage, the installation surface may need to be
strengthened.