Proface APL3000B - Node Box PC - Manual (Page 38)

Chapter 2 Part Names and Functions
2-11
2.4 PL-3900T Series
A: Power LED / RAS Status Lamp (POWER)
B: Disk Access Lamp (DISK)
C: Front Cover
D: Hardware Reset Switch (RESET)
In the normal operation status, restarts the PL unit.
In the Soft OFF status, resets the unit to the normal
operation status.
E: USB Interface (USB)
1 port. Complies with USB 2.0.
Uses a “TYPE-A” connector.
F: DVI-I interface (DVI-I)
For analog RGB output only.
*1
DVI-I 29 pin socket type.
G: Ethernet interface (LAN1)
10BASE-T/100BASE-TX/1000BASE-T Auto
Changeover. This interface uses an RJ-45 type
modular jack connector (8 pins).
H: Ethernet interface (LAN2)
10BASE-T/100BASE-TX Auto Changeover. This
interface uses an RJ-45 type modular jack
connector (8 pins).
LED Indicates
Green (lit)
Normal operation
(power is on)
Green
(blinking)
Soft OFF state
Orange (lit)
System monitor error
(RAS error)
Orange/Red
(blinking) Backlight burnout is
detected
Not lit Power is OFF
LED Indicates
Green (lit)
When HDD/SSD or IDE is
accessed
Not lit
When neither HDD/SSD nor
IDE is accessed
*1 DVI monitor cannot be connected. Connect Analog RGB monitor using DVI-I-RGB Conversion Cable.
1.1 System Design (page 1-2)
D E
A B
F
I J
L
M
P
Q
T
S
N
O N
A
G
H
R
K
C
D
Front
Right side
(2 slot type)
SEE