Proface APL3000B - Node Box PC - Manual (Page 49)

PL3000 Series Hardware Manual
3-8
„ Additional Memory Combinations
When adding more memory, it is recommended to install it in the combinations shown below for the best
performance.
„ Expansion Slots
„ Expansion slot supply current and external load current limit
Provide the expansion slots so that the external load current including the power-supply current load for the
PCI and the power-supply current load for the USB, RAS and COM does not exceed the values described in
the table below.
‹ Total current load
Expansion slot
PCI Rev.2.3 (33MHz) 2 slots/4 slots
„
Expansion Slots (page 3-8)
Clock Accuracy
*6
±180 sec. /month (range of error depending on the situation temperature
and power-off)
*1 Even though the monitor connected to a PL unit matches the specifications of the PL
unit's output signal, the display may not be correct. Please test your monitor with the
PL unit prior to operation.
*2 Only when the panel computer is used.
*3 Only when the panel computer with Keypad is used.
*4 Do not insert or remove the unit connected to the IDE during conduction because the
unit does not support hot-swap.
*5 When connecting Pro-face FP3000 Series to PL-3000B Series, use the Pro-face DVI-
D cable (10m) FP-DV01-100. For details, please refer to “3.4.1 Internal switches of
the control box” (page 3-16).
*6 The clock, RTC, built-in the PL unit has a slight timing error. The range if the error will
be between +300 and -300 sec. / month, depending on the PL unit’s conditions such
as lifetime usage or temperature difference. If you use the PL unit in a system where
timing is critical, adjust the clock in regular intervals.
Total capacity Slot 1 Slot 2
512MB 512MB -
1GB
512MB 512MB
1GB -
2GB
1GB 1GB
2GB -
4GB 2GB 2GB
Slot Type Slot No. Compliant bus Available board size
2 slot type
4 slot type Slot 1
PCI Rev.2.3 (5 V)
180 x 106.68mm
[7.09 x 4.2in.] or less Slot 2
4 slot type
Slot 3 255 x 106.68mm
[10.04 x 4.2in.] or less Slot 4
Power Supply Capacity DC5V DC12V DC-12V DC3.3V
Current load
PCI (2 slots) 2.0A 1.0A 0.1A 1.0A
PCI (4 slots) 4.0A 1.0A 0.1A 2.0A
USB (4 ports) 2.0A — — —
USB (5 ports) *1
*1 Only when the panel computer is used.
2.5A — — —
RAS (1 port) — 0.1A — —
COM (2 ports) 1.0A — — —
SEE