Nematron Pointe Controller User Manual
Page 295
Pointe Controller User Guide
Appendix A: OptiLogic Technical Specifications
293
Indicator n – Bit that turns the indicator on/off. When the bit becomes
ON, the indicator is turned on. When the bit becomes OFF, the indicator is
turned OFF. Mapped to an Output Bit tag (%QX).
To configure an Indicator, click the
to the right and select a tag from
the pop-up menu. Each tag can be used only once.
Indicator n Flash – Bit that quickly flashes the indicator. (The indicator
itself must already be on.) When the bit becomes ON, the indicator starts
flashing. When the bit becomes OFF, the indicator stops flashing. Mapped
to an Output Bit (%QX).
To configure an Indicator Flash, click the
to the right and select a tag
from the pop-up menu. Each tag can be used only once.
NOTE: You can leave any or all Indicators unconfigured, but if you do, those I/O
points will not be available to your project.
Buttons tab
This tab controls the five white pushbuttons on the OL3850 panel.
LED Separation – Option to control the red LEDs embedded in the
pushbuttons, separate from the actual ON/OFF states of the buttons. (The
setting applies to all five buttons.)
o
If Disabled (default), then each button’s LED directly reflects the
current ON/OFF state of the button.
o
If Enabled, then each button LED can be turned on/off
independently using the LED parameter (below).
To configure LED Separation, click the
to the right and select an option
(Disabled or Enabled) from the pop-up menu.
NOTE: This configuration applies to a button only if the button is also set
Momentary (see below).