General commands, Turn on and turn off, Assign – Nematron Pointe Controller User Manual
Page 300: B.1 general commands, B.1.1 turn on and turn off, B.1.2 assign
Appendix B: Flow Chart Command Reference
Pointe Controller User Guide
298
B.1
General Commands
General commands (in a
Process block
) are used to set and clear Logic Memory
tags, to enable and disable Flow Charts, and to insert a timed delay in the chart
execution.
B.1.1 Turn On and Turn Off
These commands can be selected from the
General commands
list.
When used in a Flow Chart, the Turn On and Turn Off commands set a specified
Bit tag to 1 or 0, respectively.
Parameters for these commands include:
Tag – The Bit tag to be turned on or off by the command. Bit-type tags
include Input Bits (%IX), Memory Bits (%MX), and Output Bits (%QX).
To configure the Tag parameter, click the
button to open a standard
Select Tag
dialog.
B.1.2 Assign
This command can be selected from the
General commands
list.
When used in a Flow Chart, the Assign command writes a value to a specified tag.