Triton FT5000XP PC-BASED ATMS User Manual - Manual (Page 205)

Software Release Notes
Triton Systems Page 3 of 5 April 10, 2009
Introduction
This document describes the changes to the RL5000/FT5000 XP 1.0.23 software version for
Prism.
Platforms Affected
This release is for the following PrismXP families:
• RL5000
• FT5000
Hardware Requirements
• RL5000
• FT5000
Software Requirements
The following load files are included with this release:
• Prism5K-1_0_23_0.tlf – Update load for Field Upgrades
• Prism5K-1_0_23_0_Lockdown.tlf – Update load for Field Upgrades
Important: The TLF installer requires with Prism5K 1.00.00.18 or higher loaded prior to
installing. Lockdown upgrade should only be installed on a lockdown system.
Prism 1.0.23 Build
• Kalignite Version 2.1.0 Update 30
• SP (Build 41763)
Description of Changes
Scheduled Reboot feature was implemented
Management Functions now has an option in Terminal Configuration, General Parameters
called “Reboots Daily at 3AM”. When this option is enabled, the ATM will automatically reboot
at 3AM each day.
TcpIp: terminal stops responding to host commands
There was a timing issue, where a host linkup event was received while the terminal was still in
the Open state. This caused the terminal to get out of sync with the host, and the terminal
stopped responding to host commands. This release corrects this situation.