Triton FT5000XP PC-BASED ATMS User Manual - Manual (Page 43)

2 3
R
EPLENISHING
C
ASSETTES
3. Move the pusher plate against the notes with just enough pressure to hold
the notes in the correct position when closing the lid and inserting the
cassette into the mechanism (Figure 4-11).
I
NSTALLING
N
OTE
C
ASSETTES
Using the reverse of the steps used to remove the note cassette from the mecha-
nism, slide the note cassette into its slot in the mechanism. Keep the cassette
level as you load it, and make sure the cassette is fully inserted. Once all cas-
settes have been filled and reinserted, they are ready to be <Locked> into
position following the Replenish Cassette(s) function prompts.
Figure 4-11. Moving pusher plate
against notes.
Figure 4-12. “Pawls” extended.
Figure 4-13. Closing lid.
4. Move the white plastic levers (Pawls) on the pusher plate to their fully
extended position. This will allow the pusher plate to retract and release
pressure from the note stack when an unlock command is sent to the
dispenser (Fig. 4-12).
5. Close the cassette lid. Fold the lid
down to its locked position. The
release button should “pop” out,
allowing the lid to mate cleanly with
the body of the cassette. You may
need to “tap” the lid firmly along
the front edge to achieve this. Turn
the key counterclockwise to lock
the cassette (Figure 4-13).
* IMPORTANT *
Before locking cassettes, it is recommended to check the Reject Cassette for
any rejected notes. The procedures for the reject cassette are described next.