Triton FT5000XP PC-BASED ATMS User Manual - Manual (Page 49)

2 9
P
REVENTATIVE
M
AINTENANCE
3. Press and hold the paper feed
button until the paper clears the
front of the printer.
4. Remove the existing paper roll or
empty spindle (as appropriate) from
the paper support bracket.
5. Unwind about 18 inches from the
end of the new roll of paper. Using
scissors, cut off the excess. Make
sure all the paper that has glue on
it is removed from the end of the
roll.
6. Install the new paper roll on the
spindle. Place the paper roll (w/
spindle) on the paper support
bracket by sliding ends of spindle
on to the bracket shown. Ensure
the paper feeds from the TOP of
the roll!
** CAUTION **
Do not pull the paper backward
through the printer. This may leave
paper fragments that can cause pa-
per jams.
7. Insert the edge of the paper roll
into the printer take-up slot.
Note: Paper feeds over the bar.
The printer will automatically grip
and pull the paper into the paper
path. If the paper feeds
automatically, skip to Step 10. If
the paper does not feed
automatically, continue with Step
8.
Paper feed
button