Triton FT5000XP PC-BASED ATMS User Manual - Manual (Page 51)

3 1
P
REVENTATIVE
M
AINTENANCE
R
EPLENISHING
R
ECEIPT
P
APER
(FT5000 XP )
NOTE: This operation must be com-
pleted with the AC power applied to
the ATM.
1. Open the left side service panel on
the cabinet sleeve.
2. If paper remains on the roll, cut
the paper between the roll and the
input to the printer with a pair of
scissors.
3. Press and hold the paper feed
button until the paper clears the
front of the printer.
4. Remove the existing paper roll or
empty spindle (as appropriate) from
the paper support bracket.
5. Unwind about 18 inches from the
end of the new roll of paper. Using
scissors, cut off the excess. Make
sure all the paper that has glue on
it is removed from the end of the
roll.
6. Install the new paper roll on the
spindle. Place the paper roll (w/
spindle) on the paper support bra-
cket by sliding ends of spindle on
to the bracket. Ensure the paper
feeds from the TOP of the roll!.
** CAUTION **
Do not pull the paper backward
through the printer. This may leave
paper fragments that can cause pa-
per jams.
* NOTE *
Triton recommends the use of 20#
thermal printer paper (Triton P/N
05403-00053). This receipt paper has
been shown to improve performance
and reliability.
Paper feed
button
Paper support
bracket