Triton FT5000XP PC-BASED ATMS User Manual - Manual (Page 52)

3 2
M
ODEL
RL/FT5000 XP U
SER
M
ANUAL
7. Insert the edge of the paper roll
into the printer take-up slot.The
printer will automatically grip and
pull the paper into the paper path.
If the paper feeds automatically,
skip to Step 10. If the paper does
not feed automatically, continue
with Step 8.
8. If the paper is not automatically
taken-up by the printer, check the
tension roller lever on the printer
chassis. Grasp the handle shown
and lift up. Pivot assembly down
until assembly is fully open.
9. The blue tension lever is located
on the right side. It must be in the
closed position (blue lever facing
towards the right). If not, just move
the lever (moves in 3 positions) to
the correct position. Close the
assembly and retry to feed the
printer paper. If successful,
continue with Step 10. If the paper
is not taken up automatically,
contact your service provider.
10. From the Rear Service Panel, go to
Management Functions >
Diagnostics > Printer and perform
a “Print Test Data”.