Control switch operation – Fire-Lite LDM-32F Lamp Drivers User Manual
Page 40
Appendix A: Sensiscan 2000
Control Switch Operation
40
LDM-32F PN 50055:C 03/20/01
Control Switch Operation
Circuit corresponds to a specific I/O module installed in user configured
Sensiscan 2000.
The first 8 control switches of the LDM-32F will correspond to CPU switch
functions as shown below, if “8-Point Shift” is not selected.
With “8-Point Shift” selected, the first 8 control switches move to the 3rd LDM-
E32F and are assigned to Circuits 57 through 64 as shown below.
Note: It is assumed that Sensiscan 2000 systems with “8-Point Shift” selected will be 56
zones/points or less.
Table 10 Switch Control Functions
Switch
Position
LDM-32F
-----
3rd LDM-E32F
1
Acknowledge
Not Used
2
Signal Silence
Not Used
3
System Reset
Not Used
4
Not Used
Not Used
5
NAC #1
Not Used
6
NAC #2
Not Used
7
Municipal Tie
Not Used
8
Alarm Relay
Not Used
9
Not Used
Acknowledge
10
Not Used
Signal Silence
11
Not Used
System Reset
12
Not Used
Not Used
13
Not Used
NAC #1
14
Not Used
NAC #2
15
Not Used
Municipal Tie
16
Not Used
Alarm Relay