Fire-Lite LDM-32F Lamp Drivers - Manual (Page 42)

Appendix B: MS-9200 Configuration
42
LDM-32F PN 50055:C 03/20/01
Configuration
The control panel needs to be programmed to either “Points” or “Zones”,
depending on which type of address is to be annunciated.
LDM Address Switches (SW1 & SW2) must be set to address ‘01’, ‘02’, ‘03’
or ‘04’. The CPU will differentiate between the addresses.
• For Zones use address 01 (56 zones).
• For Points use addresses 01, 02, 03 and 04 (198 points).
Note: Do not omit any address when annunciating 198 points or the MS-9200 will indicate
a constant trouble.
Alarm Only Annunciation of Zones
The table below illustrates the configuration of the LDM Series modules to
annunciate the alarm state of all 56 software zones (no zone troubles), and two
NACs, with the first eight points of address ‘01’ dedicated to the MS-9200
system function LEDs (see Figure 29 below).
Table 11 Alarm Only Setup
Alarm Only Annunciation of Zones - With 8-Point Shift
The table below illustrates the configuration of the LDM Series modules to
annunciate the alarm state of all 56 software zones (no zone troubles), and two
NACs, with the last eight points of address ‘01’ dedicated to the MS-9200
system function LEDs (see Figure 29 below).
Table 12 Alarm Only Setup with Shift
Figure 29 System Functions to Output Connectors - 1
LDM Module
Address ‘01’
LDM Output Connectors
J5 J6 J7 J8
LDM-32F Sys Funct Z1 to Z8 Z9 to Z16 Z17 to Z24
LDM-E32F Z25 to Z32 Z33 to Z40 Z41 to Z48 Z49 to Z56
LDM Module
Address ‘01’
LDM Output Connectors
J5 J6 J7 J8
LDM-32F Z1 to Z8 Z9 to Z16 Z17 to Z24 Z25 to Z32
LDM-E32F Z33 to Z40 Z41 to Z48 Z49 to Z56 Sys Funct
1 2 3 4 5 6 7 8
J5
25 26 27 28 29 30 31 32
J8
System Alarm System Alarm
Not Used Not Used
LD
M3
2F-
J
5J8.cdr